FFMmodel protection capacitorwith high voltage resistancein series being RC is comp osedofvoltage absorption device,itfitswellwith 35kv electric system.due to vacuum breaker(or other non-heavy switch),it produces the transition voltage to protect the product with high voltage from damaging,it is also used on other occasions with high voltage capacitor.

      型号说明 model meanings

    主要技术指标 main techniqueindessign
    1. 电容偏差-5~+10%;
    2. 损耗角正切值tan δ<0.05%;
    3. 电介质的电容强度2.15μ,历时1min;
    4. 其余技术要求均按照《GB.T4704-32 高压并联电容器》。
    1.Capacitance Deviation:-5~+10% ;
    2.Tangent of Loss Angle tanδ<0.05% ;
    3.Electrical Strenth of Dielectric Medium 2.1 5μ Last a period of time:1min;
    4.The other technology requirementis accordingto" GB.T4704-32High Voltage Shunt Capacitor".

    使用条件 servicecondition
    1. 防护电容器安装运行的海拔高度不超过1000m,环境空气温度为-40~+40℃。相对湿度不大于90%。
    2. 安装场所应无腐蚀气体、蒸气和导电性或爆炸性尘埃,并无剧烈的机械振动。
    3. 电容器投入运行时,其端子上的剩余电压不超过额定电压的10%。
    4. 过载荷
    4.1 稳定过电压
    4.2 操作过电压
    电容器的承受不重击穿开关所产生的1.5μn 的过渡过电压( 峰值)。
    4.3 稳态过电流
    电容器能在1.5In 稳态过电流下运行,这个过电流是由于谐波及,最大容差和高至1.2In 的过电流共同作用的结果。
    1.Height a bove sea level of capacitor’s installation and
    shipping is not more than 1000m. Env ironmental air
    temperature is-40 ℃ ~+40 ℃ Relative humidity is not more than 90% ;
    2.There is no corruption gas,smoke,conductive or explosive dust,acute machine tremor in iastallation location no harmfuI gas or smoke.no conductive performance or acute tremor;
    3.When cap a citors run,the spare voltage of its terminal is not more than10% of rated voltage;
    4.Over Loading
    4.1 Stabilization Voltage
       Stabilization voltage can continuously run ac the Voltage of 1.00μn and can also lastingly run at the industrial frequency voltage of 1.2μn.
    4.2 Operated Voltage
       The bearing capacitor should not heav ily punch switch produced transition Voltage of 1.5μn(buzzing valuel).
    4.3 Steady State Electricity
       Capacitor can be operated underthe 1.5In steady current. Duetcits harmonious wave,the result of current caused the max difference and height of 1.2In together.